Leister SONORA S1 Manual Del Usuario página 8

Service and repair
Repairs should only be carried out by authorised Leister Service Cen-
tres. They guarantee a correct and reliable repair service within 24
hours, using original spare parts in accordance with the circuit dia-
grams and spare parts lists.
Warranty
• For this tool, we generally provide a warranty of one (1) year from the date of
purchase (verified by invoice or delivery document). Damage that has occurred
will be corrected by replacement or repair. Heating elements are excluded from
this warranty.
• Additional claims shall be excluded, subject to statutory regulations.
• Damage caused by normal wear, overloading or improper handling is excluded
from the guarantee.
• Guarantee claims will be rejected for tools that have been altered or changed by
the purchaser.
Putting into Operation
Before putting into operation, check power supply cord (1) and connector as well as
extension cable for electrical and mechanical damage.
Safety of persons from accidental start-up protection if an interruption to
power supply occurs: The device has an accidental start-up protection function.
If the power supply is cut off, the SONORA S1 switches off automatically. If the
voltage returns after the outage, the device switches automatically to COOL
DOWN mode and the heating element remains switched off for safety reasons.
If the MENU button is then pressed, the device then returns to the menu that was
selected before the interruption to power supply.
Attach the nozzle to the heating element pipe if required
120 Connect tool to rated voltage
230
8
Leister SONORA S1 / Hot Air Tool Translation of the original operating instructions
Switching On
Main switch
ON
I
Switching Off
The device heating is switched off and the
1 × press
air flow switched to maximum.
The device cools down.
At the end of your work, always select
When the device is cooled,
the main switch to position
STAND-BY energy saving mode
The STAND BY mode can be used for short pauses in work. The energy consumption
is lower and the noise level is reduced.
If the device is ready The device switches to STAND BY
for operation mode (air level 1). The temperature
press 2 ×
remains unchanged.
Energy consumption is reduced.
STAND-BY appears on the display.
Press 1 × MENU
(Device is ready
for operation)
0 Disconnect power supply
cord form the line/mains