Suzuki GW250L3 Instrucciones Para El Montaje página 6

6/7
1. Cut off the attached template.
Drilling of
Mounting
2. Affix the cut out template to the
Holes
reverse side of the frame center
cover.
3. Open a 34 mm hole on the
reverse side of the frame center
cover to the position of the hole
shown by the template.
Take care so as not to damage
the frame center cover sur-
face.
4. Remount
cover to the frame upper cover.
1. Install the frame upper cover to
Mounting of
Top Case
the
Carrier
reverse procedure of removal.
2. Fit the cap to the top case car-
rier.
3. Set the washer (M8).
GENUINE SUZUKI ACCESSORIES
NOTICE
the frame
vehicle by taking
center
the
Cap
Washer Washer Washer
(M8) (M8) (M8)
Frame center cover
Template