Publicidad
Step
Step 7
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the below
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (F) to the LEFT END (B2). Use the screws in
å
the HINGES. See the next step for adjustments.
Fasten a PULL (97K) to the DOOR (F). Use two BLACK 7/8"
å
MACHINE SCREWS (37S).
Repeat this step for the other door.
å
Hinge
www.sauder.com/services
Stop
Mounting
screw
97K
37S
BLACK 7/8" MACHINE SCREW
(4 used for the PULLS)
F
411985
Pro Tip: Lift with your
legs. And, you know,
your arms.
B2
Page 11
Publicidad
