Publicidad
Step 4
Slide the FEET (31E and 32E) into the notches in the SKIRTS (H and R).
å
Use a hammer to drive a PROPEL NUT (14M) into the holes in the FEET (31E and 32E). Now, turn an ADJUSTABLE
å
GLIDE (18E) completely into each PROPEL NUT.
Fasten the SKIRTS (H and R) to the BOTTOM (D2). Use four BLACK 9/16" WAFER HEAD SCREWS (33S) through the
å
FEET and into the BOTTOM.
NOTE: Start all screws a few turns before tightening any of them. Use the exact holes shown in the FEET (32E).
å
32E
31E
R
31E
R
BLACK 9/16" WAFER HEAD SCREW
(4 used in this step)
Page 8
32E
H
R
D2
H
R
33S
18E
(4 used)
14M
411985
www.sauder.com/services
Publicidad
