Cybex Platinum SIRONA Z i-SIZE Guía De Usuario página 9

PRODUCT PARTS
Battery compartment (1)
Base (2)
Load leg (3)
Newborn inlay (4)
Size indicator (5)
ISOFIX-Release buttons (6)
ISOFIX-Locking arms (7)
ISOFIX-Anchorage points (8)
ISOFIX-Indicator (9)
Load leg adjustment button (10)
Load leg indicator (11)
Seat locking indicator (12)
Linear side-impact protection
(L.S.P.) (13)
PREPARING TO INSTALL THE BASE Z
Before using the base for the first time, the plastic strip must be removed from the
Battery compartment (1) on the load leg. The Base (2) will emit an audible warning
signal until it has been correctly installed. If the Load leg (3) is folded out and
there is no sound, the battery must be checked. To check the battery, the Battery
compartment (1) on the back of the load leg can be opened with a screwdriver.
The battery may only be replaced with a CR2032 size battery.
L.S.P. Release button (14)
Green seat release button (15)
Upper seat release button (16)
Load leg parking position (17)
Headrest (18)
Headrest adjustment handle (19)
Position adjustment handle (20)
Belt adjustment button (21)
Shoulder belt (22)
Belt buckle (23)
Buckle tongue (24)
Lap belts (25)
Central adjustment belt (26)
User guide compartment (27)
DIFFERENT USES OF THE SEAT
45 – 105 cm,
0 M – approx. 4 Y
max. 18 kg
BASE Z BASE Z BASE Z BASE Z
BASE Z One BASE Z One BASE Z One
BASE Z
BASE Z
BASE Z One BASE Z One
45 – 60 cm > 60 cm
The Newborn inlay (4) will already be placed in the car seat when you take it out
of the box. This should be removed if your child is taller than 60 cm. To remove the
Newborn inlay (4) pull off the headrest cover and then remove the inlay. The Size
indicator (5) shows the size your child must reach before it is permitted to convert
the seat for forward-facing use.
THE CORRECT POSITION IN THE VEHICLE
This is an i-Size Enhanced Child Restraint System. It is approved according
to UN Regulation No. R129/02, for use in i-Size compatible vehicle seating
positions as indicated by vehicle manufacturers in their vehicle user manuals. If
your vehicle does not have an i-Size seating position, please check the enclosed
vehicle Type List. You can obtain the most up-to-date version of the Type List from
www.cybex-online.com.
INSTALLATION IN THE VEHICLE
Always ensure that...
• the backrests in the vehicle are locked in their upright position.
• when installing the child seat on the front passenger seat, adjust the vehicle
seat as far back as possible.
76 – 105 cm,
> 15 M – approx. 4Y
max. 18 kg
BASE Z BASE Z
BASE Z
BASE Z
EN
7