Electrical - Flotec FP5100 Serie Manual Del Usuario

Electrical

Motor Switch Settings
Dual-voltage motors (motors that can operate at either
115 or 230 volts), are set at the factory to 230 volts. Do
not change motor voltage setting if line voltage is 230
volts, or if you have a single voltage motor.
NOTICE Never wire a 115 volt motor to a 230 volt line.
Remove Motor End Cover
If you have a dual-voltage motor, and will connect it to
115 volts, follow the procedure below.
You will need to remove the motor end cover to change
the voltage setting.
Your motor terminal board (located under the motor end
cover) should look like Figure 4.
End Cover Screws
Motor
End Cover
Figure 3 - Removing Motor End Cover
For parts or assistance, call Flotec Customer Service at
Selecting 115 volts with the Dial Type
Voltage Selector
4693
Figure 4 - Voltage set to 230 volts, Dial Type; turn dial
to select 115 volts. Insert tool in slot to turn dial.
To change to 115 volts:
1. Make sure power is off.
2. Turn the dial counter-clockwise until 115 shows in
the dial window.
3. Attach the power lead wires to the power lead
terminals. Make sure the wires are secure.
4. Attach the ground wire to the green ground screw.
5. Reinstall the Motor end cover.
Go to Wiring Connections below.
or kill. Disconnect power to motor before working on
pump or motor. Ground motor before connecting to
power supply.
For 230 Volt
For 115 Volt
Risk of electric shock. Can shock, burn
800-365-6832
6