Haier QVM7167RNSS Instrucciones De Instalación página 10

MARKING THE MOUNTING HOLES
D
OPTION 2: USE METAL BRACKET AS TEMPLATE
NOTE: Refer to step C "DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET on page 8 for aligning instructions.
STEP 1:
Draw a vertical line on the wall at the center of the
30" space.
STEP 2:
Installer uses bracket to make 2 marks. First mark
is made by using the stampled slot in bracket. Second mark is
made on the ouside edge of bracket.
Make a mark
here on the
outside edge
of the bracket
STEP 3:
Installer moves bracket to the other side of the
cabinets and makes 2 more marks. Marks are the same as
STEP 2, just opposite side.
Make a mark here, along
inside bottom of the
stamped slot provided
(same as Step 1).
10
Installation Instructions
Make a mark here, along inside
bottom of the stamped slot
provided.
Make a mark
here on the
outside edge of
the bracket
STEP 4:
Installer uses a level to draw a horizontal line that
connects the two marks made with the stamped slot in the
bracket.
Horizontal line
STEP 5:
Installer places the mounting bracket on the wall as
shown in the picture. Draw circles on the wall at holes A and B.
Draw at least one circle in area C. At least one circle MUST line
up with a wall stud.
Mark hole locations for
A, B, and area C.
A
C
Place bracket within the lines created in previous steps.
STEP 6:
Set mounting bracket aside and drill holes at all
marked locations. If there is a stud, drill a 3/16" hole for wood
screws. For holes that do not line up with a stud, drill a 5/8" hole
for a toggle bolt.
B
31-7000110 Rev. 1