Installation Instructions - Haier QVM7167RNSS Instrucciones De Instalación

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All
safety messages will follow the safety alert symbol and the word "DANGER", "WARNING", or "CAUTION". These words
are defined as:
DANGER
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
IMPORTANT SAFETY INSTRUCTIONS
A qualified electrician must perform a ground
continuity check on the wall receptacle before
beginning the installation to ensure that the outlet box
is properly grounded. If not properly grounded, or if the
wall receptacle does not meet electrical requirements
noted (under ELECTRICAL REQUIREMENTS), a
qualified electrician should be employed to correct any
deficiencies.
Ensure
proper
ground
exists before
use
this appliance is equipped with a three-prong
(grounding) plug which mates with a standard
three-prong (grounding) wall receptacle to minimize
the possibility of electric shock hazard from this
appliance.
Where a standard two-prong wall receptacle is
encountered, it must be replaced with a properly
grounded three-prong wall receptacle, installed by a
qualified electrician.
2

Installation Instructions

WARNING
Risk of Electric Shock.
Can cause injury or
death: Remove house
fuse or
open circuit breaker
before beginning
installation to avoid
severe or fatal shock
injury.
WARNING
Risk of Electric Shock.
Can cause injury or
death: THIS APPLIANCE
MUST BE PROPERLY
GROUNDED to avoid
severe or fatal shock.
The power cord of
RISK OF ELECTRIC SHOCK
Can cause injury or death: DO
WARNING
NOT, under any circumstances,
cut, deform or remove any of
the prongs from the power cord. Do not use with an
extension cord. Failure to comply may cause fire.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14.5 amps
and 1.7 kilowatts. This product must be connected to a
supply circuit of the proper voltage and frequency. Wire
size must conform to the requirements of the National
Electrical Code or the prevailing local code for this
kilowatt rating. The power supply cord and plug should
be brought to a separate 15- to 20-ampere branch
circuit single grounded outlet. The outlet box should
be located in the cabinet above the microwave oven.
The outlet box and supply circuit should be installed
by a qualified electrician and conform to the National
Electrical Code or the prevailing local code.
FOR YOUR SAFETY:
For personal safety,
CAUTION
the mounting surface must be
capable of supporting the cabinet load, in addition to
the added weight of this 63–85 pound product, plus
additional oven loads of up to 50 pounds or a total weight
of 113–135 pounds.
CAUTION
For personal safety, this product
cannot be installed in cabinet
arrangements such as an island or a peninsula. It must be
mounted to BOTH a top cabinet AND a wall.
To avoid the risk of personal
CAUTION
injury (back injury or other injuries
due to excessive weight of the microwave oven) or
property damage, you will need two people to install this
microwave oven.
31-7000110 Rev. 1