Changing The Instrument Settings; Configuration Menu Sce; Configuration Of The Sce 020; Adjusting The Decimal Places - (M2) - Parker SensoControl SCE-020 Instrucciones Para El Manejo

4.0

Changing the instrument settings

4.1

Configuration menu SCE-020

After removing the front panel (by carefully lifting it with a screwdriver),
the keys and the LED display are exposed. Press the SET key to
get into the configuration menu. To change or select the settings use
the + / - keys. The setting is adopted upon pressing SET . The next
menu can be selected by the + / - keys. To save all the altered or
adjusted settings the menu End (M1) must be selected. Press the
SET key to save the programmed configuration. After this step the
instrument accepts all changes and switches automatically into the
operation mode Measuring and Display .
4.2

Configuration of the SCE 020-01

Press SET to call up the configuration menu (see chapter 4.1). The
desired menu is selected with the + / - keys: End...., decimal point,
in 0, in FS (see Fig. 2).

4.2.1 Adjusting the decimal places - (M2) :

Select the menu item M2 with the + / - keys and press the SET key
to activate the parameter selection. Then choose the number of
decimal places with the + / - keys. To adjust one decimal place the
display shows 000.1 , for two decimal places 00.02 . End the setting
procedure by pressing the SET key.
The number of decimal places should match the full-scale range:
Example:
Decimal place
0000 or 0004
000.1 or 000.5
00.02 or 00.06
0.003 or 0.007
Full-scale LED display
150 bar 0150
150 l / min 150.0
15 °C 16.00
1.5 bar 1.500
- 4 -