Basic Operations - Yamaha RX-V692 Manual De Instrucciones

TO PLAY A SOURCE
: Provided for RX-V692 only.
1
28
40
60
Set to the "
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
VCR
VIDEO AUX TAPE (MD) MON
* The name of the selected input source will appear on
the display.
4
Select the main speakers to be used.
SPEAKERS
* If you use two main speaker systems, press both the A
and B switches.

BASIC OPERATIONS

2
7
4
VOLUME
l6
20 l2
8
4
2
0
–dB
∞
" position.
POWER
TV/DBS DVD/LD
2CH/6CH
A B
ON OFF
3 1, 6
l6
20 l2
28 8
40 4
2
60
0
–dB
5
Play the source. (For detailed information on the
tuning operation, refer to page 26.)
6
VOLUME
20
28
40
60
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 25) and use the digital
sound field processor. (Refer to page 32.)
Notes on using the input selector buttons
Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
* To select the source connected to the VIDEO AUX
terminals on the front panel, press VIDEO AUX.
The selection of TAPE (MD) MON cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE (MD) MON again so that "TAPE MONITOR"
disappears from the display.
When you select a button other than TAPE (MD) MON,
make sure that "TAPE MONITOR" is not illuminated on the
display.
If you select the input selector button for a video source
without canceling the selection of TAPE (MD) MON, the
playback result will be the video image from the video
source and the sound from the audio tape (or MD etc.).
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
To turn off the power
Press the POWER switch again.
l6
l2
8
4
2
0
–dB
23