Putting Into Operation - Cattini Oleopneumatica YAK 330/N Manual Uso Y Manutención

EN
- The instruction "Keep upright" is clearly visible on the cardboard box containing the jack.
- Depending on the number of jacks shipped, pallets of different sizes are used.
- Either transpallets or forklift-trucks are used for handling.

PUTTING INTO OPERATION

ASSEMBLY
1. Take the handle, the jack and the extensions out of the cardboard box.
2. Loosen the two nuts POS. 7 EXPLODED DRAWING YAK330/N POS. 7 EXPLODED DRAWING YAK330/N
3. Loosen screw POS. 10 YAK330/N POS. 10 YAK330/N
assembled.
4. Fit the handle (the air distributor must be facing the pistons) inserting the coupling in the groove , put the parts removed
previously into the hole of the handle, tighten screw
5. Connect the two air pipes between the jack and the handle with the quick couplings on the chassis respecting the colour
indication as showed on the sticker on the chassis itself. DWG. 11
CONNECTION TO THE COMPRESSED AIR SYSTEM
- Compressed air enters into the jack circuit through the quick coupling on the top of the manual lifting/descending controls;
it is therefore necessary to have a connecting pipe with a quick coupling compatible with that of the jack. Check that the air
supply pipe has a useful passage of at least 6 mm and it is not pinched or restricted anywhere. DWG. 12
WORKING AIR PRESSURE: 8 - 12 BAR
- Absolutely never put the following into the compressed air circuit: hydraulic or Vaseline oil, brake liquid, kerosene or other
liquids.
-Install a filter dehumidifier-lubricator unit in the compressed air system.
- If you want to lubricate the compressed air circuit use exclusively:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100;
SHELL TELLUS 100; BP ENERGOL HP 100
from inside the chassis. DWG. 10
from the chassis and remove parts
POS. 10 YAK330/N POS. 10 YAK330/N
POS. 8, 9, 10 YAK330/N POS. 8, 9, 10 YAK330/N
and then tighten nut POS. 7 YAK330/N POS. 7 YAK330/N
keeping them
.
13