Hinge - Sauder Cannery Bridge 416082 Manual De Usuario

Step 16
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram. If
å
it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (G) to the RIGHT END (A) as shown in the lower diagram. Use the screws in the HINGES. You should
å
start each SCREW a few turns before completely tightening any of them.
Fasten a KNOB (95K) to the DOOR (G). Use a GRAY 1-3/8" MACHINE SCREW (39S).
å
Peel the FELT DISC from the FELT DISC CARD (1M) and stick them on the DOOR (G) where they will come in contact with
å
the UPRIGHT (C).
Repeat this step for the other DOOR (G).
å
See the next step for DOOR adjustments.
å
Page 20
A
C
GRAY 1-3/8" MACHINE SCREW
(2 used in this step)
416082
Stop
Mounting
screw
1M
1M
G
95K
1M
1M
39S

Hinge

www.sauder.com/services