Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
(18) After rinsing, insert the second (and third) medium container as well, ensuring that the pipe
openings are aligned and safely connected by the rubber seals. Retract all handles and make sure
that all media containers lie flush on top of each other. Attach second and third rubber seals to rele-
vant media container above.
(19) Then place the white filter pad
the top container in such a way that it rests on top of the
on
retracted handle.
The white pad must not lie under the handle, the cut-out for the pipe opening must
Attention:
remain free.
Place lattice screen on top (cut-out over pipe opening).
If additional filtering with active carbon is intended, the active carbon sponge (order no.
Note:
2628260) is placed under the handle in the top container. The white filter pad is the last layer over
the retracted handle of the container.
Closing filter, inserting adapter.
(20) Check that the sealing gasket of the filter head fits exactly and remove any soiling. Place head
on filter canister, ensuring that the hose joint of the filter head is inserted into the hose duct of the
media containers. Close all four EZ clips.
(21) Then place adapter onto the joints (locking bar to the front) and push the lever towards the
adapter as far as it will go. This pulls the adapter into its sealing and at the same time opens it
automatically.
Start-up
(22) For priming the pump is slowly pressed down to its limit and then released. The strong pres-
sure of the spring returns it automatically to its starting position, thereby sucking water into the fil-
ter canister.
(23) As soon as the canister is full the mains plug can be con-nected to start up the filter.
(24) Then the closing plug is inserted in the open end of the spray bar.
Should the water circulation not be complete, due to unfavourable hose conduit, the priming
Note:
support can be activated repeatedly.
Controlling the flow rate.
(25) To adjust the filter performance on the delivery side according to requirement, the lever on the
adapter can be pulled forwards slowly. The float in the inspection glass of the indicator shows the
current flow rate of the water.
Optical Control.
(26) The indicator provides permanent information on the current amount of circulating water and
thus signals possible faults.
If the float touches the red bar of the scale, this means that full performance is no longer being
achieve and that the filter system must be checked.
16
Publicidad
