Checking The Water Dispenser Line - Dacor DYF42SBI Serie Instrucciones De Instalación

Checking the water dispenser line

• In order to operate the ice maker properly, water pressure between 30 and 120 psi
(207 and 827 kPa) is required.
• The water filter removes particles. It does not sterilize or destroy any micro-organisms.
• If the refrigerator is installed in an area with low water pressure (below 30 psi
(207 kPa)), you should install a booster pump to compensate for the low pressure.
• Ensure the water storage tank inside the refrigerator is properly filled initially. Push
the water dispenser lever until the air is out of the tank and continuos stream of water
is being dispensed.
COUPLER "A"
Water Supply hose
TBI_Dacor_Installation_DA68-03583A-03_EN.indd 19
TAP
Floor
Connect to the water supply line
Connect the water pipe with coupler and
tap.
• Close the main water tap.
• Connect coupler "A" to the tap.
• Every join should be sealed with sealing
tape.
CAUTION
It is recommended that a pressure valve
be installed by the plumber (30 psi
(207 kPa)).
NOTE
Supplied water line and fitting valve must
be connected to water pipe.
English 19
2020-10-15 10:39:35