Water Ace Ready Jon RRJ Manual Del Usuario página 7

Installation
22. Your local or state plumbing code may require you to
test the system with a "10 foot water column test". If
so, make certain the pump chamber lid screws are
tightened down properly and that the lid gasket is
seated. Plug the 4" diameter toilet opening (in the top
of the tank) with an expandable plumber's plug (avail-
able at hardware stores). Also plug any other openings
in the system except the highest one (normally the top
of the vent stack). Make sure that if the system is tied
in to existing vents, drains, sewers, toilets, etc., that
any openings in these system components are also
plugged securely. The system can now be tested per
code requirements. Consult your local code officials
for more information about this test.
Risk of damage to floor and possible flood-
ing. The tank and lid will expand with the water column
pressure while being tested. If you are installing the tank
under the floor, complete the testing before the floor is
installed.
23. Install the long studs and nuts (Exploded View, Key
No. 10) that are used to fasten the toilet to the tank or
subfloor.
NOTE: To tighten the studs, thread both nuts onto one
stud, then use the 1/2" wrench to tighten the upper
nut. The nuts should jam on the stud and turn it into
the threaded hole in the tank. Remove the nuts and
repeat for the second stud.
NOTE: A standard floor flange is not required.The
position of the toilet must be determined to allow the
stud to be inserted in the correct holes. Install the wax
ring. Be sure to align the studs for installation of the
toilet bowl in the desired direction. (i.e., If the vent
and discharge pipe are to be installed behind the wall
to one side of the Ready Jon, you can turn the toilet
sideways on the tank top so that the flush tank is flat
against the wall – see Figure 5).
Toilet
Mounting
Bolts
Toilet Mounted straight on tank
Toilet Mounting Bolts
Figure 5: Alternate Positions for Mounting Toilet.
24. Install the wax toilet bowl seal(s) at the hole on top of
the tank and install the toilet following the instructions
from the wax seal package.
NOTE: Do not use a wax seal having a flange that extends
into the tank; it may cause clogging. If a 1/2" or 1/4" floor
is installed over the tank, the appropriate floor flange
extender seal kit must be used. See "NOTE: Floor Seal:"
under "Pre-Installation", Page 2. Hook up the water line to
the toilet. Turn on the water and fill the toilet tank. Test for
leaks, flush the toilet, and allow the pump to cycle to
ensure proper operation.
7
Access
Hatch
Wall
Toilet rotated 90° on tank