Hidden Cam - Sauder Twin Platform Bed Instrucciones De Montaje

Step 11
1
D16
Groove
Insert the DRAWER SIDES (D16 and D17) at an angle
å
into the slot at each end of the DRAWER FRONT (E2).
3
G
E2
Surface with

HIDDEN CAM

Fasten two DRAWER BRACES (G) to the DRAWER
å
FRONT (E2). Tighten two HIDDEN CAMS.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
E2
D17
Maximum
Arrow
210 degrees
Minimum
190 degrees
G
2
With the palm of your hand, tap the
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D16
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D987) into the grooves
å
in the DRAWER SIDES (D16 and D17) and DRAWER
FRONT (E2).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D219
D16
G
Be sure the DRAWER
BOTTOM inserts into the
DRAWER BACK groove.
Fasten the DRAWER BACK (D219) to the DRAWER
å
SIDES (D16 and D17) and DRAWER BRACES (G). Use six
BLACK 1-9/16" FLAT HEAD SCREWS. Repeat this step
for the other drawer.
415546
D987
E2
D17
30S
(12 used in this step)
G
D17
Page 15