Silverline 868861 Manual Del Usuario página 6

Cordless tool safety
Earthed
FUSE
GREEN/YELLOW
OR GREEN
BLUE BROWN
(Neutral) (Live)
• The wires in this product are coloured:
Blue
Brown
Green & Yellow
• As the colours may not correspond with the coloured markings in your
plug, proceed as follows.
• The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black, the wire which
is coloured brown must be connected to the terminal which is marked
L or coloured red.
• This appliance must be protected by a suitable fuse.
• To prevent fire or shock hazard, do not expose this product to rain/
water or moisture.
• There are no user serviceable parts inside except those referred to in
this manual. Always refer servicing to qualified service personnel.
Never remove any part of the casing unless qualified to do so;
this unit contains dangerous voltages.
• Use of a residual current device (RCD) will reduce the risk of
electric shock.
NEVER CONNECT THE BROWN OR BLUE WIRE TO THE EARTH PIN OF THE
13 AMP PLUG. IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
Dangerous environment
• Do not use power tools in damp or wet conditions, or expose them
to rain. Provide adequate surrounding work space and keep area well
lit. Do not use power tools where there is a risk of explosion or fire from
combustible material, flammable liquids, flammable gasses, or dust of an
explosive nature.
Protect yourself from vibration
• Hand held power tools may produce vibration. Vibration can cause
disease. Gloves to keep the operator warm may help to maintain good
blood circulation in the fingers. Hand held tools should not be used for
long periods without a break.
Maintain your power tool
• Ensure all ventilation holes are kept clear at all times. Overheating and
fire may otherwise result.
• Do not alter your power tool in any way. Any attempt to modify your
tool will invalidate its guarantee and could result in serious injury
to yourself, or others around you.
Do not abuse the power cord
• Be sure your charger cable is in good condition. Always have a damaged
cable replaced at an authorised service centre before using it.
Never yank or pull the cable to disconnect it from the power socket.
Never carry your charger by its cable. Keep the cable away from damp,
heat, oil solvents, and sharp edges.
Don't leave the tool running unattended
• Always wait until your tool has come to a complete stop, or has
otherwise totally stopped functioning, before leaving it.
868861_Instructions.indd 6
Double Insulated
FUSE
BLUE BROWN
(Neutral) (Live)
Neutral (N)
Live (L)
Earth (E)
Use the battery charger correctly
• Refer to the part of this manual relating to use of the battery charger
before attempting to charge the battery. Do not attempt to use the
charger with any batteries other than those supplied. Keep your
battery charger clean as foreign objects or dirt may cause a short,
or block air vents.
• Failure to follow these instructions may cause overheating resulting
in fire.
Use batteries correctly
• Only charge batteries using charger provided. Only use batteries provided
with this power tool, or others recommended by the supplier. Keep
your batteries clean as foreign objects or dirt may cause a short.
Allow batteries to cool for 15 minutes after charging or heavy use.
• Failure to follow these instructions may cause overheating resulting
in fire.
• When not in use, batteries should be stored in a dry place, near to
room temperature (20˚C). Ensure that batteries can not accidentally
short in storage.
4
20/10/2011 14:24