Application Method - PULOX PO-900 Instrucciones Para El Usuario

6. Operating

6.1 Application Method

6.1.1
Insert the lemo probe into the lemo jack of the device (The probe is
limited to the one that is provided by our company; and can't be
replaced with the similar one by other manufacturers), then put the
finger into the probe as Figure 4.
A. Long press power button until the device is turned on.If use
alternating current,make sure that the power supply line is
connected accurately.
B. Do not shake the finger and keep the patient in a stable state
during the process.
C. The data can be read directly from the screen in the measure
interface.
Fingernails and the luminescent tube should be at the same
side.
If the alarm function is on, the device will provide alarm
signal when probe or finger is out.
6.1.2 Alarm pause
A. The alarm includes the alarm of measure data going beyond the
limits, the alarm of low-voltage, the alarm of finger out.
B. When alarm is on, short press the alarm pause button to pause
the alarm. It is renewed after a period of time. The alarm pause
time can be set in the menu.
C. Only the alarm sound can be turned off, the prompt information
that is shown on the display can't be turned off.
Figure 4 Probe connecting
EN