View Of The Back Panel - PULOX PO-900 Instrucciones Para El Usuario

Display area: display measure information
Button Area:
1. Mode switch button: click it to switch mode (Measure interface 1
/ Measure interface 2)
2. Alarm pause button: when alarm happens, press it to make alarm
sound pause.The pause time could be set by menu.
3. Return button: return to the previous menu.
4. Up button/down button/left button/right button: change the
choice bar position left/right button: set part function
5. Menu button: in waveform measure interface, press the button to
enter the menu setting; in menu interface,press the button to
enter the corresponding submenu.
6. Power button: in power-off state, long press the button to turn on
the device; in power-on state, long press the button to turn off
the device.

5.2 View of the Back Panel

USB port: It is used to connect computer to transmit data by data
line.
R pinhole Restoration key: restore the device.
The computer intended to be connected with this device, shall be
approved and certificated according to IEC 60950.
During data transmitting, please do not use this device with
patient.
Power supply jack: power supply line interface
5.3 Accessories
User Manual, power supply line, data line, Oximeter probe
Optional:
Other Oximeter probe (refer to <Probe Application Introduction>)
Figure 3 Back view
EN