Compressor Oil Specifications - Speedaire 10 HP Manual De Instrucciones De Operación Y Partes

Speedaire
Operating Instructions & Parts Manual
Models 1WD87, 1WD88, 1WD90

Compressor Oil Specifications

Compressors are factory filled
with Speedaire hydrocarbon
based recip lubricant.
This is an ISO 100 non-detergent
industrial lubricant with rust
and oxidation inhibitors
specially formulated for
reciprocating compressors.
It is recommended this
compressor be maintained
using this oil for ambient
temperatures above 32 degrees F.
Speedaire synthetic is a premium
grade diester based synthetic
lubricant providing excellent
performance in high temperature
applications.
Do not
mix types, weights or brands.
"Emulsi-fication
of oil (white milky substance)
indicates unsafe accumulation of
moisture and may be evidence
compressor is oversized for
application. Failure to promptly
consult your local distributor, or
Speedaire
Customer Service, can be
grounds to deny warranty."
For Service and Warranty, Call: 1-888-303-1344.
NOTE:
1. Normal break-in period of
Speedaire air
compressors is 25 hours.
2. For the first 100 hours of
compressor operation, a
careful and regular check of
the oil level should be made.
Maintain oil level at the full
line.
Changing To Synthetic
Lubricant
(Applies to diester based synthetic
lubricant only)
If changing to synthetic lubricant,
the following steps must be
completed.
1. Compressor must run for a
25 hour break-in period
using Speedaire ISO 100 oil.
11
2. Thoroughly drain existing oil
from crankcase.
3. Fill crankcase with a full
charge of synthetic
lubricant.
4. Run compressor for
200 hours.
5. Stop compressor and
thoroughly drain the
synthetic lubricant.
6. Add a full charge of
synthetic lubricant.
7. Compressor is now ready to
run for extended period
before next lubricant
change.
Lubricant
DESCRIPTION PART NUMBER
1 Quart Mineral
1WG50
Lubricant
1 Quart Synthetic 1WG49
E
N
G
L
I
S
H