Avaya Advanced Gateway 2330 Manual Del Usuario página 22

English
Prerequisites
• Ensure you have a module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
1. Remove the three screws securing the left-hand side mounting bracket to the
2. Remove the three screws securing the left-hand side of the top cover to the
3. Remove the three screws securing the right-hand side bracket to the chassis and
4. Remove the three screws securing the right-hand side of the top cover to the
5. Slowly slide the top cover back to take it off of the Advanced Gateway 2330.
Installing the Advanced Gateway 2330 internal PVIM module
Use the procedure in this section to install an internal PVIM module.
Prerequisites
• Ensure you have a PVIM module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
22 Regulatory Information
chassis and the top cover.
See the following figure for reference.
chassis.
the top cover.
chassis.
Comments? infodev@avaya.com
August 2013