Avaya Advanced Gateway 2330 Manual Del Usuario página 23

Procedure steps
1. Remove the Advanced Gateway 2330 top cover. See Removing the Advanced
2. Locate the internal PVIM module connector slot.
3. Ensure the PVIM slot is clear of debris. Protective tape is placed over the SO-DIMM
4. Holding the PVIM by its edges, insert the module in the slot on the Main Board,
Removing the Advanced Gateway 2330 internal PVIM module
Use the procedure in this section to remove a PVIM module from the Advanced Gateway
2330.
Prerequisites
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
• Ensure you have an antistatic bag or sheet available for the PVIM that you are
removing.
Procedure steps
1. Remove the Advanced Gateway 2330 top cover. See Removing the Advanced
Regulatory Information
Gateway 2330 top cover.
Voltage:
Do not open the Advanced Gateway 2330 top cover while the unit is powered.
See the following figure for reference.
and PVIM slots during the manufacturing process; remove this tape if it is
present.
pushing down gently, but firmly, to fully seat the module. The release latches close
when the PVIM is properly installed.
Gateway 2330 top cover.
Advanced Gateway 2330 modules
August 2013 23