Publicidad
Step 10
Carefully turn your unit over onto its front edges and
å
tighten the two HIDDEN CAMS in the SMALL BACK (E).
Unfold the LARGE BACK (H) and lay it over your unit.
å
Make equal margins along all four edges of the LARGE
å
BACK (H). Push on opposite corners of your unit if needed
to make it "square".
Fasten the bottom edge of the LARGE BACK (H) to your
å
unit. Use eight BLACK 9/16" LARGE HEAD SCREWS (1S)
into the pre-drilled holes in the SMALL BACK (E).
Fasten the sides and top edges of the LARGE BACK (H)
å
to your unit. Use the NAILS (1N).
NAIL
(22 used in this step)
Maximum
210 degrees
Minimum
190 degrees
www.sauder.com/services
1N
E
A
Arrow
Caution
Do not stand the unit upright without the
BACKS fastened. The unit may collapse.
BLACK 9/16" LARGE HEAD SCREW
B
416532
1S
(8 used in this step)
A tracking label will
be on this surface.
Please do not remove.
H
Page 13
Publicidad
