Publicidad
Step 11
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D22
Groove
Insert the DRAWER SIDES (D22 and D23)
å
at an angle into the slot at each end of the
DRAWER FRONT (F).
3
Minimum
190 degrees
J
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (J) to the DRAWER
å
FRONT (F). Tighten one HIDDEN CAM.
Page 14
D23
F
Maximum
Arrow
210 degrees
F
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
c e
D22
F
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D704) into the
å
grooves in the DRAWER SIDES (D22 and D23) and
DRAWER FRONT (F).
4
D22
Fasten the DRAWER BACK (D80) to the DRAWER
å
SIDES (D22 and D23) and DRAWER BRACE (J). Use five
BLACK 1-9/16" FLAT HEAD SCREWS. (30S). Repeat this
step for the other drawers.
416532
e d
D704
D23
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(20 used in this step)
D80
J
D23
www.sauder.com/services
Publicidad
