Kohler Devonshire K-394 Guia De Instalacion página 5

Lavatory
Screw
Link
Gasket
Nut
Nut
Spring
Clip
Rod
Seal
Tailpiece
Style A
3. Drain Installation
- Refer to the illustrations above to determine drain style. Please
follow the appropriate instructions, based on your drain.
4. Drain Installation–Style A
- Disassemble the drain components.
- Remove the protective material from the flange.
- Wrap the bottom 2/3 of the flange threads with three layers of
sealant tape.
- Apply a ring of plumbers putty or other sealant to the underside of
the flange according to putty manufacturer's instructions. Insert the
flange into the lavatory drain hole.
- Assemble the gasket (tapered side up) and washer to the flange and
partially thread the nut to the flange. Do not fully tighten the nut at
this time.
- Install the body washer and body with the seal hole facing the back
of the lavatory and tighten.
- Ensure the seal hole is facing the back of the lavatory and fully
tighten the nut using care to avoid scratching the finish.
Kohler Co.
Seal
Stopper
Flange
Apply
Plumbers
Putty
Apply 3 layers
of sealant tape
to bottom 2/3
Washer
Body Washer
Drain Body
Apply 3 layers of
sealant tape and
a small bead of
pipe sealant to
threads
5
Style B
Refer to page 7
A
1012739-2-