To Replace The Cutting Attachment Guard; Transportation, Storage And Disposal; Transport And Storage; Technical Data - Husqvarna RA850 Manual Del Usuario

Ocultar thumbs Ver también para RA850:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Remove the lower blade, refer to
blades on page 11 .
2. Remove the shim.
Note: Save the shim until it is time to replace the
blades.
3. Install the lower blade. Tighten the screws equally
when you install the blades.
To replace the cutting attachment
guard
WARNING: Use protective gloves when you
hold the blades

Transport and storage

Make sure that the transport guard is attached
correctly to the cutting attachment when the product
is not in use, is transported or is in storage.
Keep the cutting attachment in a locked area to
prevent access for children or persons that are not
approved.

Technical data

RA850
Weight
Weight, lbs/kg
Blades
Diameter, inch/mm
Blade speed, cuts/min
12
To replace the

Transportation, storage and disposal

Technical data
Remove the 2 screws (B) and the cutting attachment
guard (A).
Install the new cutting attachment guard (A) with the
2 screws (B). Tighten the screws equally.
Attach the cutting attachment safely during
transportation to prevent damage and accidents.
Make sure that the cutting attachment is clean and
that a complete service is done before long time
storage.
B
A
5.5/2.5
9/230
4600
1050 - 002 - 12.04.2019

Publicidad

Tabla de contenido
loading

Tabla de contenido