To Assemble The Two-Piece Shaft; To Disassemble The Two-Piece Shaft; To Assemble The Cutting Attachment Guard And Trimmer Head - Husqvarna 535LK Manual Del Usuario

3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.

To assemble the two-piece shaft

1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
10

To disassemble the two-piece shaft

1. Turn the knob 3 turns or more to loosen the
2. Push and hold the button (C).
A
3. Hold tight in the end of the shaft that the engine is
4. Pull the attachment straight out of the coupling.
To assemble the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A) for
2. Put the cutting attachment guard onto the fitting on
3. Attach with the bolt (L).
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
coupling.
attached to.
C
the trimmer head. Refer to
the shaft.
A
drive disc aligns with the related hole in the gear
housing.
Accessories on page 20 .
B
C
A
331 - 008 - 24.04.2020