Uline NewAir Flex H-7259 Manual Del Usuario página 10

PROBLEM
The inflated material has an
inconsistent air-fill amount.
PROBLEMS WITH THE ROLL WINDING
PROBLEM
The roll winder will not wind
inflated material.
The roll is a different
diameter than expected.
If the problem persists or the troubleshooting section does not resolve or
describe your problem, contact Uline Customer Service at 1-800-295-5510.
PAGE 10 OF 30
TROUBLESHOOTING CONTINUED
CAUSES
Material roll improperly loaded.
Faulty material.
Ambient temperature needs to be
reset.
Electrical or mechanical failure.
Material has been affected by
storage conditions.
CAUSES
The winder is stopped.
The winder is not plugged in.
Obstruction blocking the winder or
the roll.
Electrical or mechanical failure.
The diameter setting is set
incorrectly.
Material roll is empty.
Electrical or mechanical failure.
1-800-295-5510
uline.com
RECOMMENDATIONS
Reload material roll – see Loading Material
Roll on page 4.
Load new material roll – see Loading Material
Roll on page 4.
Return material roll – contact Uline Customer
Service.
Unscrew top edge seal assembly and
reattach to recalibrate the temperature.
Contact Uline Customer Service.
Refer to storage conditions under Safety.
RECOMMENDATIONS
Press the winder start button – see
Producing Air-Filled Material in Roll Winder
Mode on page 6.
Verify that the roll winder is plugged in to
the bottom of the machine.
Verify the roll can wind free of obstruction.
Contact Uline Customer Service.
Verify diameter setting – see Producing
Air-Filled Material in Roll Winder Mode on
page 6.
Load a new roll as required – see Loading
Material Roll on page 4.
Contact Uline Customer Service.
0521 IH-7259