Maintenance And Repair; Preventative Maintenance - Uline NewAir Flex H-7259 Manual Del Usuario

PREVENTATIVE MAINTENANCE

Monthly
• Blow off all dust and debris from machine.
• Check for any unusual wear on components.
• Check for any unusual wear or buildup on the side
of the seal assembly.
REPLACING THE EDGE SEAL
Materials required:
• H-7287 Edge Sealer
NOTE: The system must be on for the following
procedure. Ensure components are cool
before proceeding.
1. Lower the clamp handle to open edge seal.
PAGE 7 OF 30

MAINTENANCE AND REPAIR

Figure 16
Clamp Handle
(Shown Open)
Figure 18
Receptacle
Holes (3)
2. Unthread the edge seal by twisting counter-clockwise.
(See Figures 17 and 18)
3. Pull the edge seal wheel away from black plastic
gear. (See Figure 18)
4. Install the new edge seal:
• Align the three connection pins on new wheel with
the three receptacle holes in seat.
NOTE: The hole pattern and pins are in a keyed
pattern.
• By hand, thread the edge seal clockwise until tight.
• Do not load film. Raise the clamp handle to close
the edge seal.
5. Press reset key (//), then, start key to calibrate the
new edge seal. Load film.
Figure 17
Black Plastic
Gear
Edge Seal
Wheel
Edge Seal
Wheel
0521 IH-7259