Uline NewAir Flex H-7259 Manual Del Usuario página 6

PRODUCING AIR-FILLED
MATERIAL IN BATCH MODE
1. Press up/down arrows to enter operator's menu.
• Select Batch Mode.
2. Adjust the batch length.
• Using the up/down arrows, set the batch length in
feet.
3. Press the start key.
• Press the start key to begin batching.
• Press the stop key to pause batching.
Start Key
PRODUCING AIR-FILLED MATERIAL IN
ROLL WINDER MODE
1. Press winder release button to lower roll winder.
2. Set the roll diameter.
• Press and hold the up/down arrows for five seconds
to enter operator's menu.
• Scroll to Menu 2 Roll Size.
• Using the up/down arrows, set the diameter from
20-40" in 2" increments.
• Press SELECT.
• Press reset (//) to return to the ready window.
PAGE 6 OF 30
OPERATION
Screen
Start
Key
Operator's
Menu
Roll Winder
Button
3. Create a three-foot length of inflated material.
• Using the start key, create a three-foot length of
inflated material.
• Using the stop key, stop the system.
4. Slide the leading edge of inflated material into
winder slot.
5. Start the roll winder.
• Toggle the winder start button to start/stop roll winder.
6. Remove the finished roll of inflated material.
• The winder will automatically stop once the roll
reaches the programmed diameter.
• Tear at a perforation and slide the roll off of winder.
READY
Batch Size 19
#1 A167P T
˿
OPERATOR MENU
Roll Size 37"
D37
SAVE
CANCEL
Up
Arrow
Down
Arrow
Stop
Key
0521 IH-7259