Package Contents; Components; Included Mounting Parts; Required Tools - Wallbox PULSAR PLUS Manual De Usuario

EN
FCC Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna of the affected ratio or television.
• Increase the separation between the charger and any affected devices.
• Connect the charger to an outlet on a circuit different from the one to which any
affected devices are connected.
• Consult the dealer or an experienced radio/TV technician for help.
Safety icons
Caution.
Risk of electric
shock.
6
Sharp element, Risk of foot injury.
risk of injurious
cuts
.
Ground earth
Flying debris,
connection
risk of eye
required.
injury.
GETTING STARTED

Package contents

Components

Wallbox Pulsar Plus Holster
with Charging Cable

Included mounting parts

x2
x2 x4
ø8 x 40mm
ø6 x 50mm ø5 x 40mm
Wall Anchors
Phillips Screws Phillips Screws

Required tools

Small, flat Phillips Screwdriver Measuring
Screwdriver or Bit Tape
Electric Drill Stud Spirit Level
3/8" (8 mm) bits Detector
PULSAR PLUS Amperage Reduction Label
SN: 123456 Wallbox Chargers S.L. UID: abcdefgh 08/2020 Made in Spain 20A
22ºF to 104ºF (-30ºC to 40ºC) PN: PUP1-U-1-5-N-002-A
Input/Output: Enclosure Type 3R
208/240VAC, 60Hz, 48A
EV Charger
Input/Output: Input/Output: 20A
208/240VAC, 60Hz, 16A 208/240VAC, 60Hz, 16A
Input/Output: Input/Output: 25A EV Charger
208/240VAC, 60Hz, 20A 208/240VAC, 60Hz, 20A
Input/Output: Input/Output: EV Charger
208/240VAC, 60Hz, 24A 208/240VAC, 60Hz, 24A 30A
EV Charger
208/240VAC, 60Hz, 32A Input/Output: Input/Output: 208/240VAC, 60Hz, 32A 40A
EV Charger
Input/Output: Input/Output: 50A
208/240VAC, 60Hz,40A 208/240VAC, 60Hz, 40A
Save this label sheet for future use.
Installation Guide Amperage Reduction
Labels
x1
x2 x2
Screw Plug T20 4 x 10mm ø3.5 x 9.5mm
Phillips Screws
(Plug-in Torx Screws
version) (Hardwire version)
T20 Screwdriver Torque
or Bit Screwdriver
(Hardwired
version)
Pencil NEMA 14-50P 240V
outlet
Ground facing down
Or electrical material
to hardwire
EN
7