Holster; Installing The Holster; Operating; Powering On - Wallbox PULSAR PLUS Manual De Usuario

EN
INSTALLATION

Holster

Installation height
Outdoor:
18 - 48 " (45 - 120cm)
Indoor:
24 - 4 8" (60 - 120cm)
16

Installing the holster

The holster is used to store your EV connector
when not in use. You may place the holster
wherever it is most convenient, being sure that
the location does not place any tension on the
charging cable.
1.
For a secure mounting, locate the holster on
a vertical wall stud or similar solid wall. Mark the
two screw holes.
2.
Drill two holes where marked with an
appropriately sized drill bit, align the holster, and
securely fasten the holster with the two provided
screws. Do not over-tighten.
x2
ø5 x 40mm
3.
Drape the charging cable around your
charger and dock your EV connector in the
holster.
• You may drape the charging cable on the
holster, the charger, or both.
Proceed to the instructions for operating
your charger in page 17.

Operating

NOTE: Once you have powered on the connected circuit, your charger will be ready to charge your EV. To
fully access your charger functions and control your charger remotely, however, you will need to download the
myWallbox app to a mobile device (smartphone or tablet) and register your charger following the directions below.
PN:XXXX-X-X-X-X-XXX-X E506750 EVSAE
----

Powering on

If you have installed a NEMA plug-in model,
insert the NEMA plug in the receptacle.
For all models, once all electrical connections
have been safely made, switch on the power to
the circuit from the circuit breaker.
The charger LED ring should light up in a steady
green. If the LEDs are not lighting, power off the
circuit at the circuit breaker and contact your
electrician to ensure proper electrical installation.

Guide to LEDs

Green: Ready.
Light blue: Connected to EV, ready for charge.
Dark blue (pulsing): Charging.
Yellow: Locked.
Red: Error (see troubleshooting section on page 18).
Registering and
connecting your charger
Download the myWallbox app to your
smartphone or tablet, log in and follow the
on-screen instructions to create an account
and register your charger. You will need to
verify your account with a valid email address.
Once you have created your account, launch
the app and follow the on-screen instructions
for connecting to and registering your charger.
To connect your charger, you will need to
enter the serial number (SN) and unique
identification number (UID). This information
may be found on your charger label.
If you have any difficulty connecting your
charger to your myWallbox app, please refer
to the "Help & Support" link on the app under
your user profile. If you have trouble with the
app, please go to support.wallbox.com/na.
17
EN