Troubleshooting - Levolor Sheer Shadings Instalación

OPERATION

Troubleshooting

Problem The shading headrail will not snap into the installation brackets.
Solution Check that the installation brackets are aligned and level.
Check that the locking lever on the installation bracket slides
over the headrail.
Problem The Tension Device has climbed to the headrail.
Solution Pull down on the spring to relieve tension and pull the Tension
Device to the bottom of the cord loop. Properly mount the Tension
Device. See the Tension Device Installation Instructions on page 11.
Problem The Tension Device grabs onto the cord upon operation.
Solution Check that the Tension Device is mounted properly. Reinstall,
if necessary. See Tension Device Installation Instructions on page 11.
Problem Vanes do not align on side-by-side shadings.
Solution Vane alignment can only be ensured within
ordered at the same time, at the same height, with the same color,
operating system and fabric, and when specified on the order form.
Check that the windows are square and the same height.
14
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 14-15
1 / " when shadings are
4
Troubleshooting
Problem The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fully raised.
Solution Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level, if necessary.
Adjust the bottom rail weight. See below.
Adjusting the Bottom Rail Weight
Release the weight clips by inserting
a flat blade screwdriver into the
weight clip and turning clockwise.
Weight
Clip
•
Move the weight in 1" increments toward the side where the
fabric is gathering.
•
Secure the weight clips in position by turning them
counterclockwise after making the adjustment.
•
Test and, if necessary, adjust again.
Problem Two-On-One Headrail Shadings Only: The center gap is not even from
the top to the bottom of the shading, interfering with the function of the
shading.
Solution Ensure the entire length of the headrail is straight and level. If the
center portion of the headrail is higher than the ends, the center gap
will close together. If the center portion of the headrail is lower than
the ends, the center gap increases. If necessary, adjust the height of
each bracket by moving it within the screw slots or by using shims.
OPERATION
Weight
Bottom Rail Clip
Weight
Fabric Roll
Gathered
Fabric
Move Weight
15
Continuous Cord Loop Operating System
1/6/21 4:47 PM