Attach The Magnetic Hold-Down Brackets (Optional); Operation; Operate The Shading - Levolor Sheer Shadings Instalación

INSTALLATION

Attach the Magnetic Hold-Down Brackets (Optional)

•
Lower the shading keeping the vanes closed.
•
Place the magnetic hold-down bracket onto the bottom rail just inside the end cap,
oriented as shown.
•
Hold the bracket while opening and closing the vanes (it may
be necessary to have someone else assist you). Adjust the bracket to the best
overall position.
•
Mark the screw location using the mounting options shown below.
— The screw should be placed in the middle of the channel.
This will allow for adjustment.
Outside Mount
Preferred
Inside Mount
Preferred
•
Drill the screw holes using a / " drill bit.
3
32
CAUTION: Use drywall anchors when mounting into drywall.
•
Attach the hold-down brackets to the mounting surface
using the screws provided.
•
If necessary, adjust bracket height by loosening the screw
and sliding the bracket up or down.
12
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 12-13
Alternate
Alternate
Adjust the
bracket
using the
channel.

Operate the Shading

To Lower the Shading and
Open the Vanes
•
Pull the rear cord of the cord loop
to lower the shading.
•
With the shading fully lowered,
continue to pull the rear cord
to tilt the bottom rail and open
the vanes.
IMPORTANT: If the
tension device moves
up the cord, you have
not secured it to the
Tension
wall or window frame.
Device
You must do so for
the shading to
Front
operate properly
Side of
and to help protect
Shading
young children from
accidental strangulation.
To Close the Vanes and Raise the Shading
•
Pull the front cord of the cord loop to
close the vanes and raise the shading.
•
If the tension device moves up the cord,
you have not secured it to the wall
or window frame. You must do so for
the shading to operate properly and
to help protect young children from
accidental strangulation.
IMPORTANT: If the shading raises or
lowers unevenly, the fabric rubs against
one end of the headrail, or the bottom
rail is uneven when fully raised, the
bottom rail weight needs to be adjusted.
See "Adjusting the Bottom Rail Weight"
on page 15.

OPERATION

Lower and Open the Vanes of the Shading
Window
Side of
Shading
Close Vanes and
Raise the Shading
Front Side Window Side
of Shading of Shading
Tension
Device
13
Continuous Cord Loop Operating System
1/6/21 4:47 PM