3-Point Hitch - Briggs & Stratton Legacy XL Manual Del Operador

Ocultar thumbs Ver también para Legacy XL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13
Auxiliary Hydraulics 
The attachment lift control lever is also used to operate
attachments that use the auxiliary hydraulic couplers located
on the right and left front frame rails. 
1. Make sure the front / rear hydraulic selector switch is in
the FRONT position. 
2. Pull the attachment lift control lever back (C, Figure 14) to
raise the attachment lift. 
3. Push the attachment lift control lever forward (D) to the
first detent to lower the attachment lift. 
4. Push the attachment lift control lever forward to the
second detent to lock the control in the "float" position.
This lets the lift mechanism to float up and down.
14
5. Move the attachment lift control lever to the left (E,
Figure 15) to angle the attachment left. 
6. Move the attachment lift control lever to the right to angle
the attachment right. 
15
Note: Many approved attachments have color coded couplers
(F, Blue/Red) and (G, Green/Yellow) to help with installation.
Match the tractor coupler with the same colored attachment
coupler. 

3-Point Hitch

WARNING
Avoid injury! A machine with an attachment installed on the
3-Point Hitch can become unstable when the attachment is
raised. Always drive slower over uneven ground and when
turning with the attachment raised. When you use a rear-
mounted attachment, always use a front weight carrier and
50 lbs. suitcase weights. Remove the front weights when
the rear attachment is removed. 
Sway Arm Assembly
Installation 
1. Attach the front of the sway arms (A, Figure 16) to the
hitch assembly (B) with clevis pins (C) and retaining clips
(D). Make sure that the arms angle out, away from the
center.
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido