To Ensure Safe Driving; Precautions Before Connecting The System; To Prevent Damage; Precautions Before Installation - Pioneer VREC-170RS Manual Del Usuario

• Never set the volume of this product so high that you cannot hear outside traffic and emergency
vehicles.
• Keep this manual handy as a reference for operating procedures and safety information.
• Certain functions (such as viewing of screen and certain button operations) offered by this product
could be dangerous (possibly resulting in serious injury or death) and/or unlawful if used while driving.
Screen display is disabled for this product while the vehicle is moving.
• Usage of the Advanced Driver Assistance Systems (ADAS) features in this product is not a substitute
for driver awareness and is not for preventing accidents. The system alerts are to be used as a
guidance only.
• It is the user's responsibility in compliance with all applicable laws and ordinance.
• Pioneer is not liable for any damage, due to installation other than described, or use of the product.
Pioneer does take responsibility whatsoever for any damage or losses incurred as a result.

To ensure safe driving

WARNING
• In some countries the viewing of video image on a display inside a vehicle even by persons other than
the driver may be illegal. Where such regulations apply, they must be obeyed.

Precautions before connecting the system

CAUTION
• Firmly install this product so it does not fall off the windscreen. If this product is not firmly installed,
it may fall off the windscreen while driving and cause an accident. Periodically inspect this product.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.
• It is extremely dangerous to allow cables to become wound around the steering column or gearstick.
Be sure to install this product, its cables, and wiring away in such so that they will not obstruct or
hinder driving.
• Make sure that the cables and wires will not interfere with or become caught in any of the vehicle's
moving parts, especially the steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any
of the vehicle's controls.
• Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires
may become damaged, resulting in a short circuit or malfunction and permanent damage to the
product.
• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may
fail to work properly.
• Never feed power to other electronic products by cutting the insulation of the power supply cable of
this product and tapping into the cable. The current capacity of the cable will be exceeded, causing
overheating.

To prevent damage

WARNING
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product.

Precautions before installation

CAUTION
Never install this product in places where, or in a manner that:
• Could injure the driver or passengers if the vehicle stops suddenly.
• May interfere with the driver's operation of the vehicle, such as on the floor in front of the driver's seat,
or close to the steering wheel or gearstick.
− 7 −