Sunny SF-RW5910 Manual Del Usuario página 14

HOW TO FILL AND EMPTY THE TANK
1. Remove the Plug (No. 72) from the Upper Tank Cover (No. 73a).
2. To fill the tank with water, refer to Fig. A. Insert the Funnel (No. 11) into the tank, then use a cup or a
bucket and Pumping Siphon (No. 42) to fill the tank. Use the water level gauge on the side of the
tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower and use the Pumping Siphon
(No. 42) to pump out the water from the tank into the bucket.
4. Insert the Plug (No. 72) back into the Upper Tank Cover (No. 73a). Wipe off excess water around
the area.
NOTE:
• Fill the tank only with tap water. Add 1 water purification tablet (1 packet is included). Never use
pool chlorine or chlorine bleach. This will damage the tank and void the warranty.
• Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace the
water in the tank.
• Do not consume the tank water. Dispose the water after pumping it out from the tank.
WATER LEVEL
• The water level gauge is on the side of the tank. There is a max level. Never fill over this limit. Filling
the tank over this limit will void the warranty.
• The resistance depends on the water level in the tank. The min level is the lowest resistance. The
max level is the highest resistance.
13