NOTE
►
Disconnect the holder with mixing knife
►
Remove the small Philips screw from the underside of the holder with mixing
knife
►
Rotate the blender
the symbol
the holder
►
Remove the sealing ring
with a flat, blunt object (e.g. made from wood) and then carefully guide
the sealing ring
Never use sharp or pointed objects for removing the sealing ring
These can damage the sealing ring
To assemble, place the sealing ring
the blender
is pointing at the symbol
the arrow
screw back in again.
■
Only clean the motor block
cutting knife
■
Clean the blender
with mixing knife
Afterwards, rinse all parts with clean water so that no detergent residue
remain on the parts.
■
Clean the cutting knife
shredding disk
disc
drive shaft adapter
the juice squeezer holder
shaft
that no detergent residue remains on the parts.
–
You can also clean these parts in the dishwasher! If possible, place the
parts in the top basket of the dishwasher. Ensure that the parts are not
trapped in any way.
■
Dry all parts thoroughly before re-using the appliance.
SKM 500 B2
.
until the arrow
on the holder
.
from the holder: Slightly lift the sealing ring
over the knife.
onto the holder
on the holder
is pointing at the symbol
with a damp cloth. Dry everything properly before re-using it.
, the blender closure
and the sealing ring
, the kneading knife
, the cutting disk
, the lid
with pusher
, as well as the dough scraper
, the fruit pulp sieve
in warm dishwater. Afterwards, rinse all parts with clean water so
from the blender
on the blender
. The blender
can then be released from
and therefore cause leaks!
back into the holder
so that the arrow
. Rotate the blender
. Then screw the small Philips
, the power cord and the knife guard for the
, the blender lid
in warm washing up water.
, the disk adapter
and the grating disk
, the mixing bowl
and the citrus press drive
for cleaning!
is pointing at
!
and place
on the blender
until
the holder
, the
, the emulsifying
, the drive shaft
, the
, the juice squeezer
GB │ MT
│
123
■
,