OEM TL 45 Instrucciones De Uso página 120

To successfully transport by forklift, follow these steps:
ACTION
S
TEP
Place the fork of the forklift under the worktop of the machine.
1
Ensure that the fork comes out from the back of the load (at least 5 cm), for a sufficient length to
2
eliminate any risk of overturning the transported part.
Lift the forks until the contact with the load
3
Note: If necessary, attach the load to the fork with clamps or similar devices.
Slowly lift the load by a few tens of centimeters and check its stability by making sure that the load
4
center of gravity is positioned in the center of the lift fork.
Tilt the forks backwards (towards the driver's seat) to ensure greater load stability during transport.
5
Adjust transport speed based on pavement and load type, avoiding abrupt manoeuvres.
6
Operator qualification
Required DPI
Lifting mean
Tools to use
ATTENTION!
Use only suitable and approved lifting means, compatible for the size and weight of the machine; do
not use steel ropes to avoid damaging the body of the machine.
Page 120
TRANSPORT WITH GRU / HOIST
Conductor of lifting means
Crane / hoist
Straps
EC-compliant use and warning instructions
CHAPTER 5 – TRANSPORT AND INSTALLATION