Device Description - Leister MONO SYSTEM Instrucciones De Funcionamiento

Device description

11
10
5
6
7
8
Preparation
• Remove MONO from the packaging.
• Loosen the screws (3) to open the cover of the connection housing (2) .
• Loosen the cable gland for the power supply (5) .
• If needed, loosen the cable gland for interface (6) .
Installation
• The device may only be installed by a trained technician.
• The surrounding temperature may not be higher than 60 °C
• The installation must ensure that
– only cold air is taken in.
– the device is not exposed to the flow of hot air from another device.
• If the air is filled with dust, use the Leister stainless steel filter (see accessories) and push onto connection ø
38 for air hose or stainless steel filter (8).
• In cases of particularly critical dusts (e.g. metal, electrically conductive or moist dusts), special filters must be
used in order to avoid short circuits in the device.
• Protect MONO against mechanical vibrations and shocks.
• Attach MONO with four Ø M4 screws to the mounting tabs (1).
• For installation dimensions, see page 3 (Size)
Connection
• The MONO must be connected by a trained technician.
• A suitable apparatus for disconnecting the device from the mains for all poles must be present in the power
supply cord!
• The device must be connected in accordance with the Wiring Diagram on page 4 of the Operating Manual:
– Carry out the wiring in the connection housing (9) .
• Tighten the cable gland for the power supply cord (5) and the cable gland for the interface (6) .
• Attach the cover for the connection housing (2) using the screws (3) .
• Mount the air hose to the air outlet (4) with a hose clip. Use hoses that are as short as possible in order to avoid
air volume losses.
• Connect MONO to the mains.
• Switch on the mains.
4
3 (4 ×)
2
9
1 (4 ×)
1 Mounting tabs
2 Connection housing cover
3 Screws for connection housing
4 Air outlet / hose connection ø 38 mm
5 Cable gland for power supply cord
6 Cable gland for interface
7 Air inlet valve with internal thread G 1"
8 Connection ø 38 for air hose or stainless steel filter
9 Connection housing
10 e-drive for air settings
11 Display
17