Leister MONO SYSTEM Instrucciones De Funcionamiento página 19

Configuration Setup menu
e-Drive Function
Press briefly 1 × = activate
Press 3 seconds = confirm
Note:
If the e-drive is pressed briefly 1x without confirming it, the values will not be saved.
Switch on the mains
Stand-by mode
3 seconds
Blower interface target
1× briefly
Potentiometer
Display Description
Blower e-drive (potentiometer)
Blower interface target 0 – 10 V
Blower interface target 4 – 20 mA
Save
Operating mode
0 – 10 volt
1× briefly
e-drive Function
turn to the right
turn to the left
Set-up menu
&
Settings are saved.
Return to operating mode.
Press 2 seconds and at the
same time slowly give it a ¼
turn to the right
3 seconds
4 –20 mA
Press e-Drive for 5 seconds
Return to Standby mode
19