Parker DME012 Manual De Instrucciones página 6

Minimum Operating Pressure
Maximum Operating Pressure DME012 - DME040
Maximum Operating Pressure DME050 - DME080
Minimum Operating Temperature
Maximum Inlet Air Temperature
Maximum Ambient Air Temperature
Noise Level
Standard Electrical Supply
Optional Electrical Supply
Nominal Dewpoint
Optional Dewpoint
Nominal ISO 8573.1 : 2010 Classification
Optional ISO 8573.1 : 2010 Classification
Standard Thread Connections
Optional Thread Connections
Approvals
CRN
CSA-US
Before continuing with the installation and commissioning of this equipment:
Ensure that it is correctly sized for the inlet pressure, taking into consideration the pressure drop caused by the valves, pipes and filters within
the system. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi/0.1MPa) below nominal
compressor output pressure.
The purge air flow is factory set for 6 bar g (87 psi g) minimum system pressure. Should the minimum supply pressure be higher or lower than
this figure the purge air flow must be reset in order to maintain the specified dewpoint. Please contact your local Parker domnick hunter office
for assistance.
Ensure that it is correctly sized for inlet temperature to meet the dewpoint specified.
-40°C (-40°F) or -70°C (-100°F).
Ensure that the electrical supply voltage and frequency meet the requirements detailed within this specification and on the equipment rating
plate.
OH0373.9C (DME012 - DME040)
OH0372.9C (DME050 - DME080)
173682 (LR56310)
230 V 1ph 50 Hz
110 V 1ph 60 Hz
Class 2 Water
Class 1 Water
5
EN
4 bar g
58 psi g
16 bar g
232 psi g
13 bar g
190 psi g
o
5 C
o
41 F
o
50 C
o
122 F
o
55 C
o
131 F
<75 dB(A)
o
-40 C
o
-40 F
o
-70 C
o
-100 F
BSPP
NPT
Description