SonoSite DICOM Guia Del Usuario página 11

To associate devices with a location
Note: The devices must be configured before you can
select them. See "Completing the DICOM
configuration pages" on page 2.
1 On the Connectivity setup page, select
DICOM Setup.
2 In the Location list, select the location of the
system.
3 In the device list, select one or more archivers,
printers, or worklist servers.
You can select a maximum of two printers,
four archivers, and one worklist server for
each location. Only one archiver can be
selected to receive in‐progress transfers.
Selected devices have a a check mark
in the left‐hand column.
4 If you want to use the MPPS service, associate
the MPPS server with the archiver:
a Select the MPPS server that you want.
(MPPS servers appear near the end of
the list.)
A check mark appears in server's left‐hand
column.
b Select the archiver.
A check mark appears in the archiver's
left‐hand column.
c Select the MPPS button.
A check mark appears in the archiver's
MPPS column.
5 If you want to use the storage commitment
service, associate the storage commitment
server with the archiver:
a Select the check box for the storage
commitment server that you want.
(Storage commitment servers appear
at the end of the list.)
A check mark appears in server's left‐hand
column.
b Select the archiver.
A check mark appears in archiver's
left‐hand column.
c Select the Set SC button.
A check mark appears in the archiver's SC
column.
6 Complete any additional configuration tasks,
and then select Done on‐screen.
A dialog box prompts you to restart the
system.
To disassociate devices with a location
1 On the Connectivity setup page, select
DICOM Setup.
2 In the Location list, select the location.
3 Do any of the following:
• To disassociate a printer, archiver,
or worklist server, select it.
• To disassociate an MPPS server from
an archiver, select the MPPS server.
• To disassociate a storage commitment
server from an archiver, select the storage
commitment server.
• To disassociate an archiver from all
servers, deselect and then reselect it.
4 Select Done on‐screen.
A dialog box prompts you to restart the
system.
To verify the connection status of devices
1 On the Connectivity setup page, select
DICOM Setup.
2 Select Verify to confirm that the associated
devices are connected. (If the Verify button
is unavailable, check cable and wireless
connections. Restart the system if you
changed configuration.)
7