Fanimation Caruso FP7000 Serie Manual Del Propietário página 8

Assembling and Hanging the Ceiling Fan
CAUTION
The fan must be hung with at least 7´ of clearance from
floor to blades (vertical position as shown in Figure 1)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Hanging the fan with blades connected may
result in damage to the fan blades.
1. To prevent damage to motor housing, leave the motor
assemblies in its packing during installation of assembled
downrod / support bar assembly. (Figure 2)
NOTE: Do not set Support Bar and Motor Assemblies on
floor or hard surface.
INSTALLATION NOTE
The motor's Top Position Indicator Tab MUST be in top
position for the motor holes to align with tube assembly
holes. (Figures 3, 4)
2. Securely attach plug from motor to socket on support
tube assembly and assemble safety cable with clamp as
shown. (Figure 3)
3. Align holes of tube with holes of motor assembly and
install three screws at each motor. Do not over-tighten.
(Figures 3, 4)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the tube assembly
and not pinched between the motor assembly and the
tube assembly.
NOTE: See page 12 for motor head angle adjustment
instructions.
Top Position
Indicator Tab
Top Location of
Threaded Hole
8
No
less than
7 ft
from fl oor
Figure 1
Figure 2
Top Location of
Screw Hole
Figure 3
Figure 4