How To Hang Your Ceiling Fan - Fanimation Caruso FP7000 Serie Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

1. Using the

⁄

˝ x 2˝ lag bolt and flat washer, attach

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, and into the building structure (Figure 1). You

will first drill a ¼˝ pilot hole into the building structure to

prevent splitting or cracking.

2. Securely attach the hanger bracket to ceiling junction

box acceptable for ceiling support.

NOTE: Ceiling support cable cannot be secured to

junction box only, it must be directly secured to ceiling

joist or structural member using the ⅜˝ x 2˝ lag bolt and

ﬂ at washer. (Figure 1)

3. Make sure the electrical supply wires, including the

hanger bracket grounding wire and safety cable are

pulled through the downrod, between the hanger bracket

and the junction box so that electrical connections can be

made later.

4. Carefully lift the fan and seat the downrod/hanger ball

assembly on the hanger bracket that was just attached to

the ceiling joist. Be sure the groove in the ball is lined up

with tab on the hanger bracket. (Figure 2)

5. Attach the safety cable to ceiling support cable. Slide

cable clamp onto safety cable (from fan). Place the end

of cable through the loop of ceiling support cable. Pull as

much cable through loop as possible. Feed end of cable

into clamp hole and firmly tighten screw (Figure 2). Cut

off excess safety cable.