Fanimation Caruso FP7000 Serie Manual Del Propietário página 9

Assembling and Hanging the Ceiling Fan (cont'd)
4. You have now completed the assembly of the downrod/
support bar/motors assembly. You can now proceed with
with step 5 below.
▲WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
▲WARNING
To avoid possible shock, do not pinch wires between the
downrod/hanger ball assembly and the hanger bracket.
INSTALLATION NOTE
HEAVY! Two or three people are required to hang the
fan.
5. Carefully lift the fan assembly and seat the downrod/
hanger ball/support bar assembly on the hanger bracket
that was just attached to the ceiling joist. Be sure the
groove in the ball is lined up with tab on the hanger bracket.
(Figure 6)
6. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and fi rmly tighten screw (Figure 6). Cut off
excess safety cable.
7. Make sure the electrical supply wires, including the
hanger bracket grounding wire are pulled through the
downrod, between the hanger bracket and the junction
box so that electrical connections can be made.
Tab
9
Figure 5
Attach Safety
Cable to Ceiling
Support Cable
Downrod/Hanger
Ball Assembly
Figure 6