Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How to Wire Your Ceiling Fan - CW3WH-CA Wall Control
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
NOTE: If fan or supply wires are different colors
h t
a
n
n i
d
c i
a
e t
, d
h
a
v
e
h t
s i
electrician.
Installing Wall Control (Figures 1 & 2):
1. With electrical power still disconnected, remove the
existing wall plate and switch. Make wiring connections
with wire nuts as shown in Figure 1.
– One black wire from wall control unit to black
(hot supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
• Attach wall control unit to outlet box using the two
6-32 screws provided.
2. Attach wall plate to the switch control front using the two
small screws provided.
3. Restore electrical power.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
Operating Instructions - CW3WH-CA Wall Control
NOTE: Do NOT operate fan without blades & blade
holders, switch cup assembly installed.
Operating & Using Wall Control (Figure 1):
1. Check the operation of the fan by moving the slide
switch on the wall control to low and then to high.
• OFF Switch – fan off
• LO Slide Switch – low fan speed
• HI Slide Switch – hi fan speed
• OFF Switch – fan off
u
n
t i
n i
s
a t
e l l
d
b
y
a
q
u
a
f i l
e i
d
11
120 VAC Supply
(User Supplied)
BLK
TO HOT
BLK
TO FAN
Figure 1
NOTE: Supply wires and fan wires
omitted for clarity.
Figure 2
Figure 1
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
