Fan Alignment And Hanger Bracket Installation - Fanimation Caruso FP7000 Serie Manual Del Propietário

Fan Alignment And Hanger Bracket Installation

INSTALLATION NOTE
Be sure that the safety cable (along with the electrical
supply wires) is pulled through the downrod when
installing the downrod to the support bar.
4. Position the bottom end of the downrod inside the
housing support located at the center of the support bar
assembly. It may be necessary to loosen the two screws
that go through the crossbar assembly if the downrod does
not slide into the housing support easily without scratching
the fi nish. Connect the downrod to the housing support
using the ¼˝ x 2 ⁄ ˝ socket head bolt and locking nut.
3
16
Securely tighten both bolt and nut. (Figure 3)
5. Slide Canopy over the downrod. (Figure 4)
6. Route wires and safety cable though the Hanger Ball
Assembly.
7. Assemble the Hanger Ball Assembly to top of the
downrod with the set screw. (Figure 4)
8. Before installing fan, measure up approximately 6-9
inches above the top of the downrod. Cut off excess wire
and strip back insulation ½˝ from end of wire.
9. Using the ⁄ ˝ x 2˝ lag bolt and flat washer, attach
3
8
safety cable to ceiling joist or wood structural member.
The lag bolt will pass through the flat washer, safety
cable loop, and into the building structure (Figure 5). You
will first drill a ¼˝ pilot hole into the building structure to
prevent splitting or cracking.
10. Securely attach the hanger bracket to ceiling junction
box acceptable for ceiling support.
NOTE: Ceiling support cable cannot be secured to
junction box only, it must be directly secured to ceiling
joist or structural member using the ⅜˝ x 2˝ lag bolt and
fl at washer. (Figure 5)
11. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger bracket
and the junction box so that electrical connections can be
made later.
12. Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached to
the ceiling joist. Be sure the groove in the ball is lined up
with tab on the hanger bracket. (Figure 6)
13. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and firmly tighten screw (Figure 6). Cut
off excess safety cable.
▲WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
▲WARNING
To avoid possible shock, do not pinch wires between the
downrod/hanger ball assembly and the hanger bracket.
Housing
Support
Downrod
Setscrew
Wood Member
(2˝ x 4˝ Approx.)
Ceiling
Junction
Box
Ceiling
Support
Cable
Tab
NOTE: Supply wires and
fan wires omitted for clarity
6
Downrod
Loosen
Loosen
Figure 3
Pin
Hanger Ball
Assembly
Canopy
Figure 4
Ceiling Joist
Hanger Bracket
Figure 5
Attach
Safety Cable to
Ceiling Support
Cable
Downrod/Hanger
Ball Assembly
Figure 6