Use Armbar; Care And Maintenance - Joie muze Manual De Instrucciones

Ocultar thumbs Ver también para muze:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 10 pairs of hook and loop fasteners on
the rain cover.
27
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
!
After the rain cover is assembled, please reassemble the parent tray on the handle.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
If the rain cover is on the stroller, always remove rain cover to prevent ripping and tearing.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
!
When using your stroller at the beach, completely clean you stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
Use Mosquito Net
Cover the stroller with the mosquito net. Follow the steps below to secure the mosquito net.
1. Attach the elastic strap to the hook on the back of the plastic.
2. Wrap bottom edge of the footrest and then stick the Velcro
3. Repeat steps above to secure mosquito net to opposite side.
The assembled mosquito net is shown as
.
28
Use Parent Tray
To assemble the parent tray, attach the parent tray to the parent tray mounts on both sides of the handle.
!
Do not place any item that may do harm to the baby and stroller in the parent tray.
!
The maximum recommended weight of the parent tray is 1.36kg/3lbs.
Use Rotating Child's Tray
Align the rotating child's tray end with matching component, and then push down to assemble.
The rotating child's tray can be pulled up on both left and right sides.
To open the rotating child's tray, press rotating child's tray release button
- 2
child's tray.
31

Use Armbar

Align the armbar end with matching component, and then push down to assemble.
The armbar can be pulled up on both left and right sides.
To open the armbar, press armbar release button
Tip
Armbar can be open for easily placing and removing child.
15
- 1
28
- 2
.
®
28
30 32
- 1
31
, and then pull up the rotating
33 35
- 1
- 2
34
, and then pull up the armbar.
34

Care and Maintenance

1. Removable seat pad may be washed in cold water and drip-dried. No bleach.
2. To clean stroller frame, use only household soap and warm water. No bleach or detergent.
3. From time to time check your stroller for loose screws, worn parts, torn material or stitching. Replace or
repair the parts as needed.
4. Excessive exposure to sun or heat could cause fading or warping of parts.
5. If stroller becomes wet, open hood and allow to dry thoroughly before storing.
6. If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get
the oil into the axle and wheel assembly.
7. If brake pedal stiff/hard to fully engage, flush any debris from brake system with clean water first before
lubricating.
8. When using your stroller at the beach or areas of high dust/sand, completely clean your stroller after use to
remove sand and salt from brake mechanisms and wheel assemblies.
29
1
16

Publicidad

Tabla de contenido
loading

Tabla de contenido