Attaching Valance; Operation; Operating Corded; Operating Cordless - Levolor Real Wood & Faux Wood Blinds Instalación

ATTACH VALANCE
•
Locate the valance clip location
indicators on the backside of the
valance that read "Clip Here."
•
Insert the clips into the groove on
the backside of the valance. Rotate
so that the end marked "TOP"
arrow is pointing up.
•
For returns, insert L-shaped return
clip into the groove on the backside
of the valance return. Align and
insert the other end of the L-shaped
return clip into the groove on the
backside of the valance.
•
Align the clips with the slots on
the bottom of the headrail and
clip into place.
CORDED
NOTE:
Tilt and Lift cords may be located on the left
or right side of the product depending on what was
selected when ordering.
NOTE:
Wand tilt is the standard / default tilt feature, tilt
cords are available as an option.
•
To raise the blind pull cord in toward the center of
the blind to release the lock; this allows you to raise
and lower the blind. Once the blind is at the desired
height, pull the cord away from the center to lock
into position.
•
To tilt the slats open or closed, pull the tilt cords up
and down to reach desired position.
CORDLESS
•
To raise the blind, firmly press and hold the
LEVOLOR button located on the bottom rail
and lift the blind to the desired position. Once
desired position is reached, release grip on the
button to lock blind in place.
•
To tilt slats open and closed, rotate the tilt wand
to achieve desired position.
Return clip "Top" or
arrow end Valance clip
(OM only)
Return clip
(OM only)
Corded & Cordless Operation

OPERATION

Valance
Slots
Corded
Cordless
17